Black BLK-SY10 Series Manuel de service télécharger pdf (Page 100)

SKYJACK, Page 9SJIII Series

Section 5 - Procedures Service and Maintenance

Reprogramming Existing Tilt Switch

Red LED

Green LED

Light Indicators

Set up button is located on this

face next to harness

1. Ensure aerial platform is parked on a firm level

surface.

2. Chock or block wheels to keep the aerial platform

from rolling forward or backward.

3. Lower/Raise the platform and secure the scissors

using the maintenance bar. (Refer to Operating

manual for Maintenance Support Procedure)

NOTE

The tilt circuit is only powered when

activating a function.

4. Remove any covers to locate and view the tilt

switch.

5. Disconnect all wires #02 from motor contactor.

6. Install jumper wire between #7 and #19 to

terminal strip.

7. Turn main disconnect switch to “

” ON position.

8. Verify switch is powered. (Red or green LED will

be continually blinking)

9. Reprogram the Tilt Switch

Press and hold the set a.

up button for 3 seconds.

Results: Both LEDs will

be OFF.

Both LEDs will flash. b.

IMPORTANT

Step “c” must be completed within

a 5 second period, or the switch will

automatically exit program mode and

return to normal operation using previously

stored data.

Press and release set up button 3 times.c.

If 5 second period has expired prior d.

completion, repeat Step “a”, “b” and “c”.

Observe program delay e.

/ stabilization time.

(Only the red LED will

blink for 4 seconds)

B o t h L E D s w i l l f.

flash for 1 second.

Results: The switch is

learning the new zero

position.

Both LEDs will turn g.

on solid for 1 second.

Results: The n ew

zero position has been

learned.

The green LED will flash and then the h.

red LED will turn on solid for 2 seconds.

Results: The switch is verifying the new

zero position.

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

Red LED

Green LED

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 115 116

Commentaires sur ces manuels

Pas de commentaire

Black BLK-SY10 Series Manuel de service Page 100

Commentaires sur ces manuels

Produits connexes et manuels pour Enregistreurs vidéo numériques (DVR) Black BLK-SY10 Series